Micro Bit remix

I remixed the Robottillo:bit that I found on Thingiverse. https://www.thingiverse.com/thing:2573930

I modified to remove the T on the back cover instead i put command strip Velcro. This was due to the speaker being added to V2 of the MicroBot.
I also cut out part of the front cover so I can have access to the additional sensor on the front.
I would suggest getting small metal bolts (5) so you can use alligator clips to still use the access point to additional features.

The back cover is a little large if you want to tighten it print at 95.5%
No support needed