Thingiverse
Mini 2.4 RC Controller Trim Stabilizer
von jmding
4
Downloads
5
Likes
0
Makes
If you don't have access to a printer, I will make these available for sale, $5 USD shipped for 2x lockers printed in grey PETG, within the continental US. Please contact me [email protected] if interested.
This part locks the trim knobs on the mini 2.4 ghz rc controller so that they wont get accidentally bumped out of place. Easy to print, install, and remove, and prettier than hot-glue.
Printing notes:
You may need to adjust your horizontal offset if the part comes out too tight/loose.
Print with the large, flat face down. Prints without supports.
I printed in PETG, which is softer and more flexible than PLA, better for this application.
This part locks the trim knobs on the mini 2.4 ghz rc controller so that they wont get accidentally bumped out of place. Easy to print, install, and remove, and prettier than hot-glue.
Printing notes:
You may need to adjust your horizontal offset if the part comes out too tight/loose.
Print with the large, flat face down. Prints without supports.
I printed in PETG, which is softer and more flexible than PLA, better for this application.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
