Thingiverse
Mini Adjustable Spool Roller
door TheWaterDrake
0
Downloads
0
Likes
0
Makes
I bought a bunch of 250g spools of various colors off of Amazon, and they are too small at about 14mm to roll in the Creality dryer I have.
You will need 608 bearings to put on the axels.
This Mini Adjustable Spool Roller fits in the Creality dryer and should be able to hold and spin 4 rolls in the dryer once I order some more 608 bearings and print another right side piece. I will add photos of that once I get it all done.
Currently the tolerance on the mini axle is a little tight on the length and a little loose on the bearing, but it works fine, and I haven't managed to redesign it. I may update it in the future as I learn modeling and can tweak the design a little. I would also like to make a left piece that fits half the width of the Creality dryer so I can have two small rolls and one big roll in the dryer at the same time.
More parts coming as I figure out how to model them, and I will post more photos when I get those done.
You will need 608 bearings to put on the axels.
This Mini Adjustable Spool Roller fits in the Creality dryer and should be able to hold and spin 4 rolls in the dryer once I order some more 608 bearings and print another right side piece. I will add photos of that once I get it all done.
Currently the tolerance on the mini axle is a little tight on the length and a little loose on the bearing, but it works fine, and I haven't managed to redesign it. I may update it in the future as I learn modeling and can tweak the design a little. I would also like to make a left piece that fits half the width of the Creality dryer so I can have two small rolls and one big roll in the dryer at the same time.
More parts coming as I figure out how to model them, and I will post more photos when I get those done.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!