Thingiverse
Mini Bookshelf
von Icewheel12
2
Downloads
2
Likes
0
Makes
Howdy!
Made this in blender so that I could put by books and notebooks somewhere.
Comes with an extension piece that adds an additional 10cm.
Without the extension it should be 22cm across.
I know, not very American.
Make sure you sand the ends before gluing the pieces together.
If you don't have a 3D print pen, then you should be able to use CA type superglue.
Please enjoy, and let me know if you have any questions or notes.
Also, one more thing, you may need to increase the ceiling layer count.
Made this in blender so that I could put by books and notebooks somewhere.
Comes with an extension piece that adds an additional 10cm.
Without the extension it should be 22cm across.
I know, not very American.
Make sure you sand the ends before gluing the pieces together.
If you don't have a 3D print pen, then you should be able to use CA type superglue.
Please enjoy, and let me know if you have any questions or notes.
Also, one more thing, you may need to increase the ceiling layer count.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!