Mini Master Spool

Parts safe for printing:
MiniMasterSpoolBottomV5
MiniMasterSpoolTopV6

[Updated: 03-03-2018]
The MimiMasterSpool Is currently in a very usable state. I have updated the bottom and the top to V5 and V6 respectively. There are 3 cable tie ditches available for pulling filament off the spool, or putting it back on. There is a hole through the center to allow for you to insert the end of the filament. There are also 4 filament end storage locations for keeping the end of the filament in a safe spot. this allows for stacking as well. I have thickened the spool ends to reduce flexing when winding or adding filament to the spool.

The Yellow portion was printed on a Prusa I2, the white half was printed on my Mp select Mini V2. Do not use support material at all! if you do you will have a fun time cleaning the threads...

Please let me know if you print this spool, leave any comments and or suggestions.
Thanks.

[Updated: 02-28-2018]
Fusion 360 crashed on me and I lost a few mod