Thingiverse
mini pod .obj
von gonzo55
0
Downloads
0
Likes
0
Makes
Hello,
This is the EVA pod that I sized down from the artist: lisagen November 11, 2015, This is her work and ALL RIGHTS ARE RESERVED FOR "HIM/HER"? Sorry not sure of the gender. This is a good fit for the U.S.S. Discovery detailed Pod Bay: 2001 Discovery (DX-1) with Pod Bay and Improvements
by flickeringsight July 21, 2020
I used a .2 nozzle on my Ender-3 with an FR of 35% " use the knob on the control panel to lower the FR ." Using the newest version of CURA. No supports and I added an .OBJ file if you wish to tweak the size. Personally I like them this size but others may want to make them slightly larger.
Again THIS IS NOT MY WORK I just sized down the EVA Pod because there is not one included with the Pod Bay upgrade.
This is the EVA pod that I sized down from the artist: lisagen November 11, 2015, This is her work and ALL RIGHTS ARE RESERVED FOR "HIM/HER"? Sorry not sure of the gender. This is a good fit for the U.S.S. Discovery detailed Pod Bay: 2001 Discovery (DX-1) with Pod Bay and Improvements
by flickeringsight July 21, 2020
I used a .2 nozzle on my Ender-3 with an FR of 35% " use the knob on the control panel to lower the FR ." Using the newest version of CURA. No supports and I added an .OBJ file if you wish to tweak the size. Personally I like them this size but others may want to make them slightly larger.
Again THIS IS NOT MY WORK I just sized down the EVA Pod because there is not one included with the Pod Bay upgrade.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!