Slicer Discord
mini Railgun – Modello 3D stampabile da MakerWorld MakerWorld
Physics & Astronomy

mini Railgun

7 Download
10 Likes
0 Makes
Vai al Modello
这是一个桌面级的电磁轨道炮,用于科普和物理实验。发射的是10mm的铝钉,能随便买得到。需要两颗M3x28mm螺丝做固定关于电容器方面,实际上电压只需要满足450V~900V范围内都可以,但是如果电压接近900V的时候储能不建议超过200J就行,主要是超过这个范围效率会降低。但是450V电压时候储能不建议超过300J,然后线圈匝数上层和下层不小于两匝就可以了。可以根据储能大小去调整。该轨道炮只要在上述范围内都可以发射发射体:10mm的铝钉,可随意购买。电压范围:450V到900V均可使用。当电压接近900V时,储能不建议超过200J,否则效率会下降。当电压在450V左右时,储能不建议超过300J。线圈匝数:上层和下层的匝数要求都不应少于两匝,具体可以根据储能情况进行调整。发射条件:只要在上述参数范围内,轨道炮都可以顺利发射。This is a desktop electromagnetic railgun designed for science education and physical experiments. The projectile is a 10mm aluminum nail, which can be easily purchased.Requires two M3x28mm screws to fix。Regarding the capacitor, the voltage only needs to be within the range of 450V to 900V, but when the voltage is close to 900V, the stored energy should not exceed 200J to maintain efficiency, as exceeding this range would reduce efficiency.However, at 450V, the stored energy should not exceed 300J. The coil turns for the upper and lower layers should not be less than two turns, and can be adjusted according to the amount of st
Categoria
Physics & Astronomy
Fonte
MakerWorld
Pubblicato
Aggiornato
Cosa serve per stampare: Intermedio Bassa affidabilità
Pezzo unico Viteria richiesta
Supporti 1/3
Assemblaggio 0/3
Impostazioni 1/3
Dimensioni piano 0/3
Post-lavorazione 1/3
Stampante
FDM / FFF
Formato file
STL
Materiale
Post-elaborazione
Viteria
Software
Cura, PrusaSlicer o simile
Ancora nessuna valutazione
Ancora nessun commento – sii il primo!

Modelli simili

6 Suggerimenti
Feed Blog Slicer Calcolatore Ricerca per immagine Invia Contatto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Aggiungi alla collezione