Thingiverse
Mini Vice
door florian_1034
170
Downloads
113
Likes
1
Makes
This is a mini vice with a fast lock/release mechanism that allow you to easily adjust the jaws opening. Also the vice comes with replaceable jaws.
In addition to the printed parts you will need:
- one M8x120mm screw
- one 3x24mm nail
-optional: - 1 x M3x5mm screw
- 1 x M3x10mm screw
You can lock the jaws with the M3 screws but they don't come off that easily anyway.
The maximum jaws opening is 74mm.
In case that the lever locks the sliding part too hard or too loose, modify the height scale of the half_locking_thread.
After print, the release mechanism may still remain locked. It needs the wear a little to work properly.
Printing time: 3 hours
In addition to the printed parts you will need:
- one M8x120mm screw
- one 3x24mm nail
-optional: - 1 x M3x5mm screw
- 1 x M3x10mm screw
You can lock the jaws with the M3 screws but they don't come off that easily anyway.
The maximum jaws opening is 74mm.
In case that the lever locks the sliding part too hard or too loose, modify the height scale of the half_locking_thread.
After print, the release mechanism may still remain locked. It needs the wear a little to work properly.
Printing time: 3 hours
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!