Thingiverse
Minimal Raspberry Pi Case
von robdmob
15
Downloads
6
Likes
0
Makes
A simple case for a Raspberry Pi designed to protect the bottom of the board from damage and short circuits.
There is no protection for the top side of the Pi but it prints quickly and gives the best possible access to the GPIO and other ports. Ideal for tinkering in the lab or classroom. Screw holes should be a good fit for 5mm M2.5 bolts.
Tested with Raspberry Pi B / 2B / 3B and 3B+.
The Raspberry Pi 4 *may* fit but I've not tested it.
There is no protection for the top side of the Pi but it prints quickly and gives the best possible access to the GPIO and other ports. Ideal for tinkering in the lab or classroom. Screw holes should be a good fit for 5mm M2.5 bolts.
Tested with Raspberry Pi B / 2B / 3B and 3B+.
The Raspberry Pi 4 *may* fit but I've not tested it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
