水滴大眼萌鸟窝

大家好！今天给大家介绍一款水滴形鸟窝，在水滴外形上设计了一只大大的眼睛，来作为鸟进出的洞口。 hello everyone! Today we will introduce a droplet shaped bird nest, which features a large eye designed on the shape of a droplet to serve as the entrance for birds to enter and exit. 鸟窝设置成落地式和悬挂式两种模式 The bird nest is set in two modes: floor standing and hanging 模型底部底座为波浪圆弧形碗，以防止爬虫类侵入，主体为水滴形结构，利于雨水滑落，水滴主体与底座波浪形碗健有一道环形沟，可以储存部分雨水，便于鸟类饮用，且兼具护城河的作用，阻挡飘落的部分爬虫。 The bottom base of the model is a wavy arc-shaped bowl to prevent the invasion of reptiles. The main body is a water droplet shaped structure, which is conducive to rainwater sliding down. There is a circular groove between the water droplet main body and the wavy bowl base, which can store some rainwater for birds to drink, and also serves as a moat to block falling reptiles. 并且在鸟窝的后侧，设计了逃生洞口，当遇到天敌来袭，鸟类可从逃生口飞出。另外，前后出口均设有挡水屋檐，尽可能的减少雨水流入窝内。窝内底座上设置了大量泄水孔，一旦窝内进水，可迅速排出。 And at the back of the bird's nest, an escape hole is designed, where birds can fly out when natural enemies attack. In addition, both the front and rear exits are equipped with water blocking eaves to minimize rainwater flow into the nest as much as possible. There are a large number of drainage holes on the base of the nest, which can quickly discharge water once it enters the nest. 下面通过图片，来看看它的效果吧！ Let's take a look at its effect through the picture below! 下面介绍一下打印参数设置：（Below is an introduction to printing parameter settings:） 材料：PLA（Material: PLA） 喷嘴：0.4mm（Nozzle: 0.4mm） 层高：0.2mm（layer height: 0.2mm） 填充图案：网格(Fill pattern: grid) 填充密度：15%(Filling density: 15%) 裙边：有(Brim:yes) 支撑：无(Support: None) 其余设置：默认(Other settings: default)