Thingiverse
Learning
Zum Modell
Model Rocket Components
187
Downloads
112
Likes
0
Makes
These are model rocket components printed in PLA.
I had a thin wall PVC pipe with a 1 5/8 OD approximately 17 inches long and decided to make a model rocket out of it.
The pipe wall is 1/16 inch thick and 170 grams.
I designed 4 whistles into the nosecone, hoping it will scream on takeoff.
Guides on the fins and shroud are sized for a 3/16 or 1/4 inch guide rod.
The assembled rocket will probably need an E or F engine.
I had a thin wall PVC pipe with a 1 5/8 OD approximately 17 inches long and decided to make a model rocket out of it.
The pipe wall is 1/16 inch thick and 170 grams.
I designed 4 whistles into the nosecone, hoping it will scream on takeoff.
Guides on the fins and shroud are sized for a 3/16 or 1/4 inch guide rod.
The assembled rocket will probably need an E or F engine.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
