Thingiverse
Model Rocket
door 67Maverick
1
Downloads
0
Likes
0
Makes
Fits standard 70mmX18mm rocket engines A, B and smaller C
Haven't shot one off yet I doubt you will recover it. Fair chance it wont survive the parachute eject stage. No parachute one solid piece.
Edit: Now I have tested them and they fly. When the eject stage hits it pops the motor out so if you colds mange to stuff a ribbon in there recovery is possible. Depending on your print settings the motor may fit a little too loose. A single wrap of electrical tape around the motor seems to do the trick.
Haven't shot one off yet I doubt you will recover it. Fair chance it wont survive the parachute eject stage. No parachute one solid piece.
Edit: Now I have tested them and they fly. When the eject stage hits it pops the motor out so if you colds mange to stuff a ribbon in there recovery is possible. Depending on your print settings the motor may fit a little too loose. A single wrap of electrical tape around the motor seems to do the trick.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
