Thingiverse
Model train switch control
von phildc
43
Downloads
32
Likes
0
Makes
Model train switch control, using two microswitches per lever.
You can mount the number of controls needed, with finishing ends.
Printed in PLA with a support but no raft. 0.2mm
This is a prototype, expect enhancements after testing.
You can mount the number of controls needed, with finishing ends.
Printed in PLA with a support but no raft. 0.2mm
This is a prototype, expect enhancements after testing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!