Modular angled stand

A modular stand to put under things so they're a better angle to use.

Designed to work with anything that has a flat base.

Originally designed for the Arturia MicroFreak, but as it's modular you can print and combine the parts included to suit whatever you want.

I printed everything with a layer height of 0.12mm, and the clearances are 0.125mm so going thicker then this will lead to things not fitting.
Print the test mortise and tenon parts and check they fit together with your settings before doing anything bigger.

The Front pieces have are either 25mm or 50mm deep.

The Mid pieces are designed to be printed with the slot facing upwards, so no support is necessary (the second picture show the recommended printing orientations).

Pieces named Mid-*-Side have a mortise cut into the side at the mid point, so they can be connected together with the Link to make a T-joint.

The back pieces are 10mm, 20mm, and 30mm high, so you can adjust the angle of the stand.