Modular Headset Stand

Ever wanted a simple stand for your headset, but its either too low or too high up, for your particular headset? I faced this problem, and wanted to make a solution, that was scalable to my needs. This build includes the following:The basea 100 mm roda 50 mm roda headset top part (with a soft groove to keep your headset from sliding)a rounded top part (if you wanted to use this stand for a helmet or similar) Settings:PLA works just fine, but PETG , ASA or ABS will work fine too.Print this in 0.20 mm with everything at default.No supports required!Infill should be set to at least 15% to make the threads sturdy enough.Use a brim for the rods (if the bed does not stick) Instructions:Print 1 base and 1top.Print 1 rod at a time and use a 10mm brim if your bed does not stick that well.To make sure that the rods print perfect, they must be standing upI suggest to print 1 rod at a time, to avoid any issues. But you could try with multiple at once.2 rods of 100mm should be sufficient for most h