Free Other STL Download - modular wine rackby Wade Zick

Parameter Suggested Value / NotesNozzle size 0.4 mm (designer also uses 0.4 mm)PrintablesLayer height 0.20–0.30 mm (designer suggests 0.30 mm)PrintablesInfill ~ 20% (designer suggests 20%)PrintablesSupport Use supports only where needed (on the build plate / under overhangs) — the designer says “Supports: On build plate only, and only under the two tenons.”PrintablesMaterial PLA, PETG or ABS (designer lists these)PrintablesPrint speed / acceleration Adjust based on your printer’s capabilities; start with moderate speeds to avoid ringing or artifactsBed adhesion Use a brim, skirt, or adhesion aid (e.g. PEI sheet, glue stick) as needed depending on materialCooling Enable part cooling for PLA; for PETG / ABS adjust cooling carefullyOrientation Orient the parts so that the tenons / mortises have good support and minimal overhangs