MakerWorld
Office
Zum Modell
Monitor Riser
65
Downloads
23
Likes
14
Makes
These are the feet of a monitor stand i created. You'll need a wooden plank to complete the stand. The lenght and the width is up to you. You only need to drill holes in it to fix it. You can also just glue it, it should hold.As it will probably hold heavy stuff, I recommend using a higher infill to be sure it'll hold.As the support is 21.5cm long, i recommend the plank to be a little larger,
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
