MakerWorld
Office
Zum Modell
Monitor stand
6
Downloads
2
Likes
2
Makes
Hello everyone, I designed a monitor stand to hold a monitor of any brand up to 24 inches in a vertical position with a tilt of about 10 degrees.The stand uses a simple plug-in system and can easily hold monitors up to 5 kg without any issues. If your monitor is larger or heavier, you can heat-fuse the plug-in system or the central connector at the base or on the back of the tilt so the filament melts and bonds together for extra strength.Have fun printing, and I’d really appreciate a positive review or constructive criticism!Unfortunately, the A1 Mini is not suitable for this print.Boost MeWith a Boost, you can support me incredibly well for free! Thank you very much!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
