Thingiverse
Monitor stand
von jeandrep
15
Downloads
16
Likes
0
Makes
Designed this monitor stand to raise my monitor 80mm from the table. Print 2 of these and slide in a piece of timber to complete.
Parts needed
* Wood : 200mm wide x 22mm thick x desired Length
* 2 x printed parts MonitorStand_2 v2
* 4 3 x 8mm wood screws
Parts needed
* Wood : 200mm wide x 22mm thick x desired Length
* 2 x printed parts MonitorStand_2 v2
* 4 3 x 8mm wood screws
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!