Thingiverse
monocore
von subdjet
39
Downloads
17
Likes
0
Makes
Monocore silencer core for dummy airsoft silencer.
Inner (bullet) hole 8mm.
Outer diameter 25mm.
Length 130mm.
Upd - printed 09.03.2019. Regular ABS.
Destroyed when removed from the table.
Low strength due to thin walls.
I do not recommend printing without selecting a strong material.
Upd - 10.03.2019
Added V2 - more tough (at any place no less than 3mm thickness).
This version must work in any direction.
Not printed yet
Not tested for efficiency yet.
Upd - 13.03.2019
Printed V2 - CoPET, 230/[email protected]
Not tested for efficiency yet.
Inner (bullet) hole 8mm.
Outer diameter 25mm.
Length 130mm.
Upd - printed 09.03.2019. Regular ABS.
Destroyed when removed from the table.
Low strength due to thin walls.
I do not recommend printing without selecting a strong material.
Upd - 10.03.2019
Added V2 - more tough (at any place no less than 3mm thickness).
This version must work in any direction.
Not printed yet
Not tested for efficiency yet.
Upd - 13.03.2019
Printed V2 - CoPET, 230/[email protected]
Not tested for efficiency yet.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!