Moon

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm  The Model is 200x200mm in size. You can change X and Y but Z must remain the same.  You may print at higher layer heights below the Min Depth of 0.48mm  Actual Depth is 4.6mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Silver Transmission Distance: 0.5 PLA BambuLab Basic Jade White Transmission Distance: 5 This print uses 4 unique filaments. Substitute as needed. Swap Instructions: Start with Black At layer #12 (1.04mm) swap to Blue Gray At layer #22 (1.84mm) swap to Silver At layer #23 (1.92mm) swap to Jade White At layer #24 (2mm) swap to Blue Gray At layer #27 (2.24mm) swap to Silver At layer #28 (2.32mm) swap to Jade White At layer #33 (2.72mm) swap to Blue Gray At layer #44 (3.6mm) swap to Silver At layer #46 (3.76mm) swap to Jade White for the rest.