MoonRise

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 4.5mm Filaments Used:PLA BambuLab Basic Red Transmission Distance: 4PLA BambuLab Basic Orange Transmission Distance: 5PLA BambuLab Basic Beige Transmission Distance: 8PLA BambuLab Basic Jade White Transmission Distance: 5PLA BambuLab Basic Black Transmission Distance: 0.3PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA BambuLab Basic Silver Transmission Distance: 0.5This print uses 7 unique filaments. Substitute as needed. Swap Instructions:Start with RedAt layer #12 (1.04mm) swap to OrangeAt layer #15 (1.28mm) swap to BeigeAt layer #21 (1.76mm) swap to Jade WhiteAt layer #25 (2.08mm) swap to BlackAt layer #33 (2.72mm) swap to Jade WhiteAt layer #35 (2.88mm) swap to Blue GrayAt layer #40 (3.28mm) swap to Jade WhiteAt layer #44 (3.6mm) swa