Morse Code Iambic Keyer

This is an iambic keyer using commonly available hardware. I generally use this by holding it in my left hand and keying with my right hand for SOTA and POTA activations. Gap spacing adjustment is a bit crude, but once you have it set, no adjustments should be necessary. The following hardware is needed:

* QTY 1 #8-32 x 3/4" flat head phillips screw
* QTY 6 #8-32 x 3/8" round head phillips screws
* QTY 3 #8 flat washers (may not need QTY 2 depending on paddle spacing desired)
* QTY 1 #8 hex nut
* QTY 1 #8 cap nut
* QTY 2 neodymium magnets, 10mm dia x 3mm thick
* QTY 3 #8 ring crimp connectors, wire size to your liking
* QTY 1 small zip tie
* QTY 1 1/8" stereo plug
* Approx. 3' of 3-conductor wire. I use telephone wire.
* Super glue

Assemble as follows:

1. Remove the jacket from the wire by approximately 2.5" and Install the three crimp connectors onto the wire.
2. Screw the 3/4" flat head screw in from the bottom of the base. The hole sizes are slightly smaller than