Tools
Zum Modell
Mostly Printed CNC -Add On- End Stop Mount
949
Downloads
477
Likes
3
Makes
Min and max end stop mount for, all three versions of
http://www.thingiverse.com/thing:724999
http://www.vicious1.com/
Easily change your home position, stop working in the same corner. Position your material where ever you want.
I printed these in PLA and they have to flex a lot to get over the rails but they seem fine after repeated tests.
If you have followed this project you probably know I am against end stops. Maximums can be very useful for when you mess up your gcode, the machine will stop if it goes too far. This works on all axis for a minimum or maximum position indicators. The ramps board will accept all 6 at once.
Wire it in the NO position and no firmware changes will be needed for the MPCNC.
http://www.thingiverse.com/thing:724999
http://www.vicious1.com/
Easily change your home position, stop working in the same corner. Position your material where ever you want.
I printed these in PLA and they have to flex a lot to get over the rails but they seem fine after repeated tests.
If you have followed this project you probably know I am against end stops. Maximums can be very useful for when you mess up your gcode, the machine will stop if it goes too far. This works on all axis for a minimum or maximum position indicators. The ramps board will accept all 6 at once.
Wire it in the NO position and no firmware changes will be needed for the MPCNC.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!