Thingiverse
Mouse trap
von darens
0
Downloads
0
Likes
0
Makes
Here is my take on a mouse trap. it comes with a small gusset on the door that will need to be cut out. Then cycle the door back and forth until it closes smoothly. This is to make sure it doesn't stay partially open when a mouse enters. There is a small ledge in the back where you can hold poison or peanut butter etc. and it won't slide around in the trap. Included is a lid to slide over opening so the mouse can't escape while transporting it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!