MP Mini Delta Power Supply Mod

This is a way to replace the stock MP Delta Mini power supply with a higher power one to maintain higher bed and extruder temperatures. BE CAREFUL OF EXTREMELY HIGH TEMPERATURES. The new power supply does help maintain higher temperatures for filaments other than PLA, and decreases preheat time a little.

The thickleg part is a modification to a part by Hank-Cowdog.

You will need a 100w 12v power supply, 3 prong rocker switch outlet, two M3 screws 8mm long with washers and 2 M3 screws 12mm long. The outlet snaps into the gap in the leg part, and the power supply is mounted with M3 short screws and washers to the PS holders. The PS holders screw into the existing spots on the Mini Delta Bed with the long screws. Screws can be found at a local hardware store easily.

Power Supply:
https://www.amazon.com/Waterproof-Transformer-thinner-Durable-3-Prong/dp/B07D9FTC77/ref=sr_1_3?crid=3LCQ2NWUWB8Z3&dchild=1&keywords=12v+100w+power+supply&qid=1610288321&sprefix=12v+100w+%2Caps%2C192&sr=