MP Select Mini V2 bed mod brackets

These are brackets I designed to upgrade the size of my print bed on the MP Select Mini V2. They allow you to attach a larger build plate. The tolerances on the holes may be a little tight so some post processing may be necessary. The ones pictured are printed with petg. When I printed them with PLA, the holders for the rods would crack if over-tightened. I made the countersinks for the the mounting nuts very tight to hold in place while attaching the new bed. Use a screw and a wrench to "pull" them into place before attaching your new build plate. There is now a PDF template to drill the holes for an MK2B PCB heat plate. It is designed for 8.5 X 11 paper, but a custom larger size is recommended. Print full size, but depending on your printers margins, it may not print the corner holes completely. If so, measure out from the center hole 104.5mm to each side to mark center for drill. Then use a square and mark 209 from top holes to bottom.

The plate I made is 9" by 12". Moun