MPCNC_SPINDLE_CONTACTOR

This design was created for the purpose of eliminating the need to use an alligator clip every time Z homing is needed. If there is a tool change during CNC operations, one may want to configure the machine to re-home the Z height automatically. You will need to enable the following three options in the Marlin config.h at a minimum:
1.#define NUM_SERVOS
2.#define Z_PROBE_SERVO_NR 0 // Defaults to SERVO 0 connector.(Pin3 on MX1 for Rambo)
3.#define Z_SERVO_ANGLES { 70, 0 } // Z Servo Deploy and Stow angles
Once again - Thank you to V1 Engineering for base MPCNC design!
Note -* My machine is a Burly J.
Note -* This is a Modification that could have undesired consequences, use at your own risk.