Thingiverse
Multi-usage shelf
von ybenoit
4
Downloads
11
Likes
0
Makes
I needed a shelf for my garage, and could not find what I was looking for, so I made this!
Everything can be printed at .2mm resolution, but I used 0.1mm for the bottom screws, used to hold the shelf in place.
Everything can be printed at .2mm resolution, but I used 0.1mm for the bottom screws, used to hold the shelf in place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
