Multiboard console holders

I fell in love with the multiboard system, I've designed and printed all those holders for my consoles in a day. You can see them getting better and better as I learn more about designing, some of them were greatly inspired by other creators. No supports needed, no special filament, no headache, 2 plates and roughly 9h of print time will give you 16 holders.All supports use 2 snaps except the vmu which only need one. Some holders may not be used by a lot of you, like the unhinged or vertical DS - for a pokedex shelled nds.The vmu is also special as it is a kite circuit gem and I don't see why anybody would display a simple vmu - other than special editions.All holders should have a little bit of wiggle room, this is to insert a small patch of felt, I use sticky felt with a width of 1mm max. Do not worry about the slight overhang on the first lines, this is normal and necessary to fit well in the snaps. Boost MeSome may be a bit too simplistic or not good enough for you, if you