Multiboard Overhead Worklight

This is my solution for wanting an overhead LED light that works with Multiboard. The files work as uploaded but this is still currently a work in progress. Functionally they are fine, aesthetically, and proper design/printing standards they are not. This is designed to use WS2812 Leds controlled via WLED. My setup is also powered by an independent 5v3A Power Supply. Read more about WLED here In the arms there are holes that snake through from the side and into the joint, then into the actual lightbar housing. These are designed to pass 3ea 20AWG wires through, it is a tight squeeze but they fit. I wanted a light where I could see no wires. The arms connect to the Multiboard panels with 2 Multipoint flush pieces on either side. The joints use an m3 heatset threaded insert on one side and a corresponding m3 screws on the other to join them together. The actual lightbar itself prints in 3 pieces and is glued together along with the Bar Joiner pieces in the cutouts for mechanical connecti