Thingiverse
Multitool Wall Mount
por ranikins
2
Descargas
2
Likes
0
Makes
A wall mount for whatever multitool I have. Made for a multitiil measuring 10.5 cm tall, 2cm deep and 5cm wide at the top, 4cm wide at the bottom.
The back plate is sheer flat for sticking to the wall with guerilla mounting tape.
In order to print it with the back plate on the printer bed, your printer needs to be tuned to bridge infill without substantial sagging, though you could just try changing orientation.
The design on the face was done by pausing the printer at the layer the design starts and changing the filament.
The back plate is sheer flat for sticking to the wall with guerilla mounting tape.
In order to print it with the back plate on the printer bed, your printer needs to be tuned to bridge infill without substantial sagging, though you could just try changing orientation.
The design on the face was done by pausing the printer at the layer the design starts and changing the filament.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
