Murder

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm  The Model is 200x200mm in size. You can adjust X and Y but Z must remain the same.  You may print at higher layer heights below the Min Depth of 0.48mm  Actual Depth is 2.2mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Gray Transmission Distance: 2 PLA PolyLite White Transmission Distance: 5 PLA BambuLab Basic Red Transmission Distance: 4 This print uses 5 unique filaments. Substitute as needed. Swap Instructions: Start with Black At layer #7 (0.64mm) swap to Blue Gray At layer #10 (0.88mm) swap to Gray At layer #13 (1.12mm) swap to White At layer #18 (1.52mm) swap to Black At layer #20 (1.68mm) swap to Red for the rest.