Thingiverse
MuzzleStache Shell System
by Distinct21
16
Downloads
23
Likes
1
Makes
This is the fileset for the Muzzlestache shot gun shells designed to work specifically with
the Trivictus WhiskerScar (created by Thanhtacles). Named the Muzzlestache in relation to the whiskers, get it?).
There are two methods you can use, either print up a new modified WhiskerScar with the rib cut out for a 19 mm OD and 16mm ID 1.7 mm thickness o ring (or some close equivalent) or you can use electrical or masking tape on an existing Whisker scar barrel (https://www.thingiverse.com/thing:5174583). You will want to put the tape about 2 mm from the end of the scar barrel so it's easier to press fit on. You want it tight enough so it doesn't fall off but you don't want it too tight where it is very difficult to put on/take off during a battle. A twisting motion helps it go on and off when you have a tighter fit. The attachment has two taper angles, closest to the inlet is to make it easier to put on the WhiskerScar like a flared magwell so you don't have to be so precise. Th
the Trivictus WhiskerScar (created by Thanhtacles). Named the Muzzlestache in relation to the whiskers, get it?).
There are two methods you can use, either print up a new modified WhiskerScar with the rib cut out for a 19 mm OD and 16mm ID 1.7 mm thickness o ring (or some close equivalent) or you can use electrical or masking tape on an existing Whisker scar barrel (https://www.thingiverse.com/thing:5174583). You will want to put the tape about 2 mm from the end of the scar barrel so it's easier to press fit on. You want it tight enough so it doesn't fall off but you don't want it too tight where it is very difficult to put on/take off during a battle. A twisting motion helps it go on and off when you have a tighter fit. The attachment has two taper angles, closest to the inlet is to make it easier to put on the WhiskerScar like a flared magwell so you don't have to be so precise. Th
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!