Thingiverse
MX5 Wind Break
von timmyisasleep
15
Downloads
20
Likes
0
Makes
This is still a work in progress.
I wanted a Wind Break for the Mazda MX5 NA but I didn't want to lose the factory C Pillar Rear Bar, hence this design.
It is made up of 4mm thick acrylic sheet bolted to 3D printed brackets that clamp to the Rear Bar.
Still to do:
- source more suitable hardwear
- make it look more OEM
Currently printed in PLA till I finalise the design.
I wanted a Wind Break for the Mazda MX5 NA but I didn't want to lose the factory C Pillar Rear Bar, hence this design.
It is made up of 4mm thick acrylic sheet bolted to 3D printed brackets that clamp to the Rear Bar.
Still to do:
- source more suitable hardwear
- make it look more OEM
Currently printed in PLA till I finalise the design.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
