Thingiverse
N scale servo uncoupler
door astrobond59
2
Downloads
1
Likes
0
Makes
This is an uncoupler system made for my Inglenook layout, used with an arduino to operate the servo.
The servo to use is a standard SG90 9G.
The height of the uncoupler is made to travel from under a plywood sheet of 10mm
Feel free to adjust the height if needed :)
You also may have to adjust the servo horn length if it is not standard.
Best Regards, Etienne Bonduelle.
The servo to use is a standard SG90 9G.
The height of the uncoupler is made to travel from under a plywood sheet of 10mm
Feel free to adjust the height if needed :)
You also may have to adjust the servo horn length if it is not standard.
Best Regards, Etienne Bonduelle.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
