Thingiverse
NES Controller Stand
door diettelo
24
Downloads
16
Likes
1
Makes
NES Original Controller
I designed my own NES Controller stand for 2 Controllers.
It´s most for the 8bitdo Modkit to make them wireless.
I dont know if 8Bitdo NES Controller would fit.
Just check dimensions: 123,5 mm x 17,5 mm
If this is smaller than it will work for your Controller.
!!!! I printed this with a Resin Printer, the position i uploaded i printed from there on the fly!!!!
I dont know if it works on FDM Printer, HEX Walls are 1,5 mm thick and 3mm deph.
I designed my own NES Controller stand for 2 Controllers.
It´s most for the 8bitdo Modkit to make them wireless.
I dont know if 8Bitdo NES Controller would fit.
Just check dimensions: 123,5 mm x 17,5 mm
If this is smaller than it will work for your Controller.
!!!! I printed this with a Resin Printer, the position i uploaded i printed from there on the fly!!!!
I dont know if it works on FDM Printer, HEX Walls are 1,5 mm thick and 3mm deph.
diettelo publiceert ook op
18 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
