Nespresso vertical buffer

Nespresso capsule vertical storage. Minimal usage of 3d printing: wool, wire, guitar string or cord can be used as rails

To install it:
1. Print it
2. Drill the holes with a bit that matches your wire diameter
3. Drill four holes in the cabinet/wall you want the thing to be installed into. Secure both parts with countersunk screws
4. Run the wire:
4.1. From one side of the up part to the same side of the down part,
4.2. Then to the other side of the down part,
4.3. Finally to the last hole in the up part.
5. Let the wire a little lose
6. Install a closed socket on the free hole of the down part, pass the wire through it, and wind it until it matches the required tension
7. Cut a piece of paper to tag the coffee flavor

PS. it can be installed upside down!