Network Rack Support Bracket - Prevent Sagging

This is a simplistic 1U network rack bracket made to help support the back of network equipment that is sagging. It is NOT made to fully support a piece of equipment, it's simply to help hold the back end up while the actual rack ears/bracket on the front of the equipment does most of the work. It's very simple and just snaps in and out of the rack. There are two plates both with a pair of brackets. One pair is solid and one pair has a hex grid infill. Both function identically, support the same amount of weight, use about the same amount of filament, and take almost the same amount of time to print. It's really up to which ever you like the look of more. These were printed in Bambu ABS and in testing were able to hold over 30 pounds each before starting to fail which should be more then they should ever have on them. ABS/ASA is highly recommended but PETG should be ok. I would not use PLA due to being too brittle and the tabs that fit into a network rack may snap easier. I