Thingiverse
Nibble OLED Riser
por ZacCac
3
Descargas
4
Likes
0
Makes
Nibble OLED Riser
Printed vertically (cylinders on bottom) at 0.12mm layer height. Other orientations may work as well. Can be printed at 0.2mm layer height but the layers are more noticeable.
This is my first design, so the measurements might be slightly off and designed to work with my printer.
The 2 circular pins are pressure fit and may be hard to fit.
Requires a M2x6 screw to mount OLED in the riser (can be shorter)
Printed vertically (cylinders on bottom) at 0.12mm layer height. Other orientations may work as well. Can be printed at 0.2mm layer height but the layers are more noticeable.
This is my first design, so the measurements might be slightly off and designed to work with my printer.
The 2 circular pins are pressure fit and may be hard to fit.
Requires a M2x6 screw to mount OLED in the riser (can be shorter)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!