Nintendo Pro Controller Switch Handle

This is a remix of the Nintendo Switch Mount for pro controller by NamelessParanoia which incorporates a movable arm from the Modular Mounting System.

# Instructions

I printed this in 0.2 mm layer height with 20% infill and supports (required) at 15% density.

1) In any order print these 4 files
- Arm Switch Holder (remix on Modular Mounting System)
- Holder.V2 (Unchanged from Nintendo Switch Mount for pro controller)
- Switch Holder Mount (remix on Nintendo Switch Mount for pro controller)
- Pro Controller Mount (remix on Nintendo Switch Mount for pro controller)
(Mount_Connector_Flat does not need to be printed, this is here to make remixing easier)

2) Assemble Prints
- Remove all support material
- I had luck with using a box cutter to remove support material from within the hinges then I used a marker tool like [this](https://www.walmart.com/ip/Rinhoo-Center-Punch-Marker-Automatic-Spring-Loaded-Marking-Starting-Tool-Steel-Hand-Window-Breaker/254635000) to r