Thingiverse
NoodleGate
von fpv_noob
12
Downloads
9
Likes
0
Makes
NoodleGate
**I present the NoodleGate. A Poor mans race gate.**
I bought a pool noodle for €2.30 and printed these holders to stick it into the grass. In total less than €5.
The noodle had a diameter of 60mm so I designed the hole to be 58mm to ensure a snug fit.
When transporting this you can stick the point into the end of the noodle to avoid losing an eye, which is always a bonus.
**I present the NoodleGate. A Poor mans race gate.**
I bought a pool noodle for €2.30 and printed these holders to stick it into the grass. In total less than €5.
The noodle had a diameter of 60mm so I designed the hole to be 58mm to ensure a snug fit.
When transporting this you can stick the point into the end of the noodle to avoid losing an eye, which is always a bonus.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!