Thingiverse
Nozzle Test
von Animus_Vox
9
Downloads
9
Likes
0
Makes
A quick test for the settings on your nozzle. Check overhangs (round, diagonal, horizontal), dimensional accuracy, and fine-tune your print settings.
Prints in approximately 15 minutes with suggested layer height and print speeds set at 40mm/s
Prints in approximately 15 minutes with suggested layer height and print speeds set at 40mm/s
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!