Nut Driver Rack

I had two sets of nut drivers rolling around in a drawer. I designed these racks with Tinkercad. The 7 nut drivers load from left to right, smallest to largest. I used my inch drivers for size, and the metric ones fit with no changes. They are in two pieces because I could not fit them on my printer bed in one piece. They mount with flathead deck screws through the holes in the front. Sliced with Cura 4.4.x, printed routinely.

The advantage of this rack over others I saw on Thingiverse is that the driver only has to be lifted 2cm and then it can be pulled out the front of the rack.