Slicer Discord
O11 Dynamic Evo Airflow Optimization Kit – Modèle 3D imprimable de MakerWorld MakerWorld
Electronics

O11 Dynamic Evo Airflow Optimization Kit

36 Téléchargements
30 Likes
14 Makes
Voir le modèle
Airflow optimization kit for Lian Li O11 Dynamic Evo. Includes gap covers for all major case perforations that's not a filter. Covers in pictures is from an ice cream box. Covers in model uses same dimmensions.Prevent air from exiting before passing through a radiator.Prevent recirculation.Help create overpressure to:force more air through AIO radiator.prevent dust sucked in. I mounted them all using a hot-glue gun. Removable glue or double-sided tape recommended.I run side + bottom as intake and rear + top including radiator as exhaust to create overpressure. I tried side with radiator but it didn't create overpressure. I only left the closest two PCI Slot covers to the GPU open, above and below. See picture.I glued excessively to make sure no vibrations can occur and hot-glue is easy to remove anyway. No support needed =) Other mods:I hot-glued the bottom fans in middle of bottom bracket to force more air into the GPU while preventing recirculation of air on inside next to MB
Catégorie
Electronics
Source
MakerWorld
Publié
Mis à jour
Ce qu'il faut pour imprimer: Intermédiaire Confiance faible
Monobloc
Supports 1/3
Assemblage 0/3
Réglages 1/3
Taille du plateau 0/3
Post-traitement 1/3
Imprimante
FDM / FFF
Format de fichier
STL
Matériau
Polycarbonate
Post-traitement
Collage
Logiciel
Cura, PrusaSlicer ou similaire
Pas encore d'évaluations
Pas encore de commentaires – soyez le premier !

Modèles similaires

6 Suggestions
Feed Blog Slicer Calculateur Recherche par image Soumettre Contact Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Ajouter à la collection