Slicer Discord
O11 Dynamic Evo Riser Feet – Modello 3D stampabile da MakerWorld MakerWorld
Electronics

O11 Dynamic Evo Riser Feet

512 Download
130 Likes
265 Makes
Vai al Modello
Riser feet for Lian Li O11 Dynamic Evo to increase airflow and to make vacuuming the bottom filter much easier. Designed to look like if it was original. Widened a little to look stable and proportional with the increase in height. Two height options:+25mm = 45mm total height. Recommended for table.+40mm = 60mm total height. Recommended for floor.Versions for both front and side mounted IO-panel (USB) available. Freshly cleaned buildplate highly recommended. Clean with soap and gently with the rough side of a dish sponge to avoid corners lifting. Alcohol less effective. I prefer no brim on this print for the clean edges. For me it still lifted a tiny bit on some corners. Worst one can be seen in +40mm picture closest corner but worth it in my opinion since it's barely visible. Seam is set to “back” not to be visible when in use. Facing plate from front, each riser is in it's intended location. Front left is for front left foot on the case, etc… Hope you like it! Tip for modding
Categoria
Electronics
Fonte
MakerWorld
Pubblicato
Aggiornato
Cosa serve per stampare: Principiante Bassa affidabilità
Pezzo unico
Supporti 1/3
Assemblaggio 0/3
Impostazioni 1/3
Dimensioni piano 0/3
Post-lavorazione 0/3
Stampante
FDM / FFF
Formato file
STL
Materiale
PLA, Polycarbonate
Software
Cura, PrusaSlicer o simile
Ancora nessuna valutazione
Ancora nessun commento – sii il primo!

Modelli simili

5 Suggerimenti
Feed Blog Slicer Calcolatore Ricerca per immagine Invia Contatto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Aggiungi alla collezione