Thingiverse
Objective O2 Amplifier mounting bracket
von mctubster
1
Downloads
0
Likes
0
Makes
Quick bracket so I can mount my Objective O2 Amplifier under my desk.
Snug fit so if your printer isn't accurate you may want to scale up very slightly.
My O2 case measures 108.6x30.0mm Corners have a radius of 3.5mm The silicon feet 1.4mm
I added 1mm to the 30mm height so I get a little pressure on the silicon feet when the bracket is installed so no movement. Original tinkercad file if you need to modify
https://www.tinkercad.com/things/9dnLR1ETGGy
Snug fit so if your printer isn't accurate you may want to scale up very slightly.
My O2 case measures 108.6x30.0mm Corners have a radius of 3.5mm The silicon feet 1.4mm
I added 1mm to the 30mm height so I get a little pressure on the silicon feet when the bracket is installed so no movement. Original tinkercad file if you need to modify
https://www.tinkercad.com/things/9dnLR1ETGGy
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!