Thingiverse
ODROID H3 Slim case
door isau1
7
Downloads
7
Likes
0
Makes
A remix of Browns Slim case for the Odroid H3/H3+. Fits flush with the heat sink and fits the standard Odroid H3/H3+ power button.
Comes in three new variants:
Bottom:
Standard - Only need screws
brazz-Inserts - Brazz inserts 6mm and stand-off 6 mm to support the odroid
brazz-Inserts Wallmount - as above but can me wall mounted using m4 screws
Top:
Standard - without vents on one side, (may lead to fewer breaks)
Vents - With vents
Cable slot - for passing SATA and power cables out of the case
Top fan cable slot - 92mm fan with m4 screws
Top fan cable slot brazz-inserts - 92mm fan with m4 screws two of the holes support 6mm inserts
May need a bit scaling up but can just be my settings and material. Tolerances are built in to the model.
Comes in three new variants:
Bottom:
Standard - Only need screws
brazz-Inserts - Brazz inserts 6mm and stand-off 6 mm to support the odroid
brazz-Inserts Wallmount - as above but can me wall mounted using m4 screws
Top:
Standard - without vents on one side, (may lead to fewer breaks)
Vents - With vents
Cable slot - for passing SATA and power cables out of the case
Top fan cable slot - 92mm fan with m4 screws
Top fan cable slot brazz-inserts - 92mm fan with m4 screws two of the holes support 6mm inserts
May need a bit scaling up but can just be my settings and material. Tolerances are built in to the model.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
