Thingiverse
Olaf
von stood
21
Downloads
12
Likes
0
Makes
Olaf the snowman
printed in pla at 0.12 layer height with 15 percent infill.
The arms can be bent to shape with a little steam from a kettle.
I also used some bristles from a broom for the hair.
printed in pla at 0.12 layer height with 15 percent infill.
The arms can be bent to shape with a little steam from a kettle.
I also used some bristles from a broom for the hair.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
