Thingiverse
Olight S2R bar mount
von T70E
17
Downloads
18
Likes
0
Makes
I really like my Olight s2r flashlight. I use it all the time around the house and typically bring it with me as part of my EDC. I designed this handlebar mount so it can now be used as a headlight on my bicycle for night riding. The design is small and simple to print without any supports. Its a tight fit for the flashlight and the handlebar but that's probably a good thing.
Hardware Used:
DIN 933 M5x45 Hex Bolt, Qty:1, https://www.mcmaster.com/#91280a244
DIN 934 M5 Hex nut, Qty:1, https://www.mcmaster.com/#90591A260
(I used a GoPro nut and bolt from my bar mount kit. But pretty much any M5 hardware will work.)
Note: this is for the front part of a Jones H-bar which is about 24mm in diameter. In theory it could work on something a bit bigger but won't fit on newer 31.8mm bars. The design is still a prototype. I haven't done much night riding with it yet.
Hardware Used:
DIN 933 M5x45 Hex Bolt, Qty:1, https://www.mcmaster.com/#91280a244
DIN 934 M5 Hex nut, Qty:1, https://www.mcmaster.com/#90591A260
(I used a GoPro nut and bolt from my bar mount kit. But pretty much any M5 hardware will work.)
Note: this is for the front part of a Jones H-bar which is about 24mm in diameter. In theory it could work on something a bit bigger but won't fit on newer 31.8mm bars. The design is still a prototype. I haven't done much night riding with it yet.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
